D
DJ-Thonfeld
Bekanntes Mitglied
- Registriert
- 26.01.2005
- Beiträge
- 215
- Reaktionspunkte
- 3
Folge dem Video um zu sehen, wie unsere Website als Web-App auf dem Startbildschirm installiert werden kann.
Anmerkung: Diese Funktion ist in einigen Browsern möglicherweise nicht verfügbar.
9 Route the signal to the main Mix 1 output.
Release the CUE switch. The CUE light-pipe turns off and the headphones
and monitor meters go quiet. Raise stereo channel 1 fader to
its top position. With the XFADE toggle switch in its central
position ‘OFF’ the signal is routed direct to the mix. The signal
is now displayed on the main meters at the same level as the
channel meter. The level is now the same throughout the
console signal path, as set by the channel gain control. This is
the ideal setting with meters averaging 0dB so giving the best
signal-to-noise performance while maintaining plenty of
headroom to avoid clipping.
kaype schrieb:Stell deine PA auf 50% (was man ja nun eigentlich so machen sollte) und machs halt so laut wie du es haben willst, was interessiert dich dann wieviel db vom Mischer zum Amp gehen?
grüsse...
However,
interconnections between more affordable 2-wire (signal, ground) unbalanced equipment and the
console are unlikely to cause problems if the cables are kept short.
Genau.Also muss ich den MIX 1 auf volle Pulle drehen und dann den Gain halt so regeln,dass nix rot leuchtet??Dann ahbe ich max Ausgang?
DJ-Thonfeld schrieb:Also muss ich den MIX 1 auf volle Pulle drehen und dann den Gain halt so regeln,dass nix rot leuchtet??Dann ahbe ich max Ausgang?